Hochdruckreiniger

Hochdruckreiniger

Sie können sich darauf verlassen, dass die Hochdruckreiniger von Champion Power Equipment praktische Funktionen mit leistungsstarken Komponenten für eine kostengünstige Selbstreinigungskraft für alle Ihre Outdoor-Projekte kombinieren.

Produkte Filtern

Entschuldigung - keine Ergebnisse für die von Ihnen ausgewählten Filter.
UK flag EU flag Modell: 100382 Champion 179 Bar (2600 PSI) 8,3 LPM Hochdruckreiniger

Champion 179 Bar (2600 PSI) 8,3 LPM Hochdruckreiniger

Capacity:
179 Bar (2600 psi)
Min Flow Rate:
8.3 Ltr/min
Start Type:
Recoil
UK flag EU flag Modell: 100384 Champion 220 Bar (3200 PSI) 9,0 LPM Hochdruckreiniger

Champion 220 Bar (3200 PSI) 9,0 LPM Hochdruckreiniger

Capacity:
220 Bar (3200 psi)
Min Flow Rate:
9 Ltr/min
Start Type:
Recoil
UK flag EU flag Modell: 100386 Champion 289 Bar (4200 PSI) 15,1 LPM Hochdruckreiniger

Champion 289 Bar (4200 PSI) 15,1 LPM Hochdruckreiniger

Capacity:
289 Bar (4200 psi)
Min Flow Rate:
15.1 Ltr/min
Start Type:
Recoil

Starting vs Max vs Running Watts

Most motor-driven products that you will connect to your generator need extra watts when they start, this is known as starting watts.

The Starting Watts listed on your generator is the wattage the generator can output for an average of 6 seconds (Inverter) or 10 minutes (Open Frame Type).

Once this period is over, and if the wattage has not reduced the Overload Protection will activate and the generator will trip using the following methods circuit breaker (frame type) and flashing overload light (Inverter), if this happens the power (wattage) needs to reduced or disconnected immediately and the generator needs to be reset by stopping the generator and turning everything to the ‘OFF’ position and leaving for minimum 2 minutes (Inverter Only).

The Maximum Watts listed on your generator is the MAX watts output the generator can run at – however it is not recommended to run your generator at the  maximum watts for periods more than average 5 minutes (Inverter) and 60 minutes (Open Frame Type). Once this period is over, and if the wattage has not reduced the Overload Protection will activate and the generator will trip using the following methods circuit breaker (frame type) and flashing overload light (Inverter), if this happens the power (wattage) needs to reduced or disconnected immediately and the generator needs to be reset by stopping the generator and turning everything to the ‘OFF’ position and leaving for minimum 2 minutes. While working in the max zone on an Inverter you will have solid red overload light this is normal.